TY - JOUR AU - Take, Seisho AU - Kikuchi, Misaki AU - Atsumi, Taro AU - Ogura, Taiga AU - Takenaka, Ryutaro AU - Koya, Haruki AU - Kinbara, Fuga PY - 2019/08/08 Y2 - 2024/03/28 TI - Monitoring of Hot Corrosion Behaviors for Alloys and Aluminide Coatings under Molten Sulfate Film with Thermal Cycles JF - Engineering Journal JA - Eng. J. VL - 23 IS - 4 SE - DO - 10.4186/ej.2019.23.4.193 UR - https://engj.org/index.php/ej/article/view/3421 SP - 193-204 AB - <p>In this study, a thin molten sulfate film was formed on the metallic samples and their corrosion processes have been monitored by electrochemical impedance technique under thermal cyclic condition. Inconel 600, nickel and aluminide diffusion coatings were used as samples. 50 mol%Na<sub>2</sub>SO<sub>4</sub>- 50 mol%Li<sub>2</sub>SO<sub>4</sub> was used for preparing the molten sulfate film. Two kinds of specially designed electrochemical cells have been used in this study. One is three-electrode configuration and another is two-electrode configuration. Electrochemical impedance measurements were used for monitoring the degradation processes for all samples tested. It was found that both corrosion resistance and the change of molten sulfate film has been monitored successfully during 6 thermal cycles. In every thermal cycle, the corrosion resistance increased when the temperature shifted to lower values and decreased with the rising of temperature. Also, A drastic increase in corrosion resistance and the resistance of the molten salt film was observed when the temperature decreased below the melting point of the mixed molten sulfate film. Although both three-electrode and two-electrode configurations were usable for electrochemical measurements under molten sulfate film, it was concluded that the newly designed two-electrode configuration is more suitable under thermal cyclic condition.</p> ER -